74141 NIXIE DRIVER DOWNLOAD

Truth Table for the , and A Chip. I was thinking about using four driver ic to drive the four nixie tubes. Nixies are fairly easy to use provided you have all the components needed and the patience to painstakingly wire everything one by one. The russian types are either or , high serial numbers are , low serial numbers are Great stuff, thanks for the info!

Uploader:	Mazucage
Date Added:	26 March 2005
File Size:	36.98 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	55998
Price:	Free* [*Free Regsitration Required]

Always connect a current limiting resistor between the anode and your power source. You can either multiplex through the cathode and some high voltage transistors, or through the TTL level logic by having a for each tube.

All are tested now. Skip to main content.

How to control a Nixie Tube with Arduino

So you'll probably need three 4x16 decoders. Since the MIC has an internal latch you only need to update the shift register at the rate of your fastest digit change, 1 minute or the update rate 741411 setting the time. So the signal comes from the audroino to the chip.

Tube socket SKon board for Nixie Tubes: So it should work to build the same thing on the arduino then. They are more or less a typical BCD to decimal decoder that you can buy today for 7 segment displays; except that they are built in with high voltage transistors.

Sign up using Facebook. You need 40 total different outputs to select and you can use 3 ICs since 3 times 16 is Before you get started, you need to get acquainted with the Nixie tube. You only have to put in the test-IC. All nixies are new not used and tested for each digit. Or does the driver correct this in some way? I also have russian njxie and "unknown" of which I have no idea if they are or Email Required, nxiie never shown.

Post Your Answer Discard By clicking "Post Your Answer", you acknowledge that you have read our updated terms of serviceprivacy policy and cookie policyand that your continued nixoe of the website is subject to these policies.

All tubes and driver - NEW, all tubes been tested!

This item is New never used, manufactured in at the original plant in Belarus. The difficulty here is the amount of wires: Home Questions Tags Users Unanswered.

How to control a Nixie Tube with Arduino –

As a matter of fact, without the IC driver it gets even more messy. This can be simply done with 4 extra lines.

You said something about that you can only do this with 3 nixi lines. I came across some threads about driving a single nixie tube with an arduino. When the green LED lights up, it's a good I never took used for my project, so I haven't thought about that this also can happen.

The 4 data lines are connected "bussed" to all 4 registers. Could the same thing be done with an arduino? A typical female 0. These type of Russian drivers are used for nixie tube clocks and other nixie tube DIY projects. From what I remember, I did this because this particular Arduino clone did not have a Vraw pin…. The Arduino Mega has like 52 io pins.

The ZM tube is driven with 2mA current.

The Arduino pins are what's going in the decoder.